Danner Pumps Submersible or External.

Matala's

BioStep Filter

All Kinds of

Filter Media's

The Eazy Pod Filter top must be level with the top of the Show Tank

Use Cinder Bricks under neath Eazy Pod to lift it up.[See Cinder blocks below out put of Eazy Pod Filter]

Attaching the pump and UV Light to the Eazy Pod Filter.

2" Rubber Boot from 2" Out Put of Eazy Pod to a 2" 90 degree Elbow. Add another 2" pvc pipe to corner around the easy pod.[See picture above]. Add another 2" 90 degree elbow to lead into Sequence 1200 seq. pump. Use a 2" Union and then add to 2" input to pump.

2" Out Put of pump to a 2" 90 degree elbow. Then lead into a 2" in put to the UV 15 Watt Which is a union. Then from the output 2" from the UV light a piece of 2" pipe to lead to the edge of the Show Tank. Add a 2" 90 degree elbow to go up ward to another 2" 90 degree elbow that would be level with the edge of the show tank.

[See picture above].

Add a piece of 2" pipe long enough to go over the edge of the show tank.

Add another 2" 90 degree elbow to drop into the show tank.

Add your Air Pump to the Filter.

Then have air line hose around the edge of the pond and put aprox. 4 air stones.

When your not Back Washing the Eazy Pod Filter the air is being used in the pond with the air stones.

Make sure the air pump is the same height as the top of the Eazy Pod so that water does not flow from tank into the air pump.

Filter for a Trickle Tower

Out put 2" The idea is that the water from the

Spray Bar will go out faster than it goes in.

Spray Bar over Filter Media .

Trickle Towers go thru the Nitrogen Cycle Very Fast.

You Can Put a Retro Drain in the Show tank so fish will not get taken into the filter.

Also a Retro Drain will draw debre more from the bottom into the filter.

Click on picture to go to the Retro Drain page.